Steam generator does not heat
Capacity:1-20t/h
Rated thermal efficiency: 100-104%
Fixed working pressure: ≤1.6MPa
Applicable fuel:natural gas etc.
Capacity:0.7-14MW
Rated thermal efficiency:96-98%
Fixed working pressure:≤1.25MPa
Applicable fuel:Natural gas, light oil, etc.
Capacity:0.7-2.8Mw
Rated thermal efficiency: 97.2-106%
Fixed working pressure:0.1MPa
Applicable fuel:Natural gas, etc.
Capacity:2.8-7.0Mw
Rated thermal efficiency:≥105.5%
Fixed working pressure:-0.02MPa
Applicable fuel:Natural gas, etc.
Capacity:99Kw
Rated thermal efficiency:97.2-104.4%
Fixed working pressure:1.0MPa
Applicable fuel:Natural gas, etc.
Capacity:0.5-4.0 t/h
Rated thermal efficiency:98%
Fixed working pressure:≤1.25MPa
Applicable fuel:electric energy
Empty the reservoir completely of old water. Add a considerable amount of vinegar and distilled water to the steam generator iron. Keep the solution to 50 percent vinegar and 50 percent distilled water. Run the steam generator iron at the highest temperature. Wait for about five minutes before you empty the water tank.Get Price
As water passes through the coil, the heat is transferred from the hot gases which causes the water to convert to steam. The generator design does not utilize a steam drum where the steam of a boiler has a disengagement area from the water in so the use of a steam/water separator to achieve 99.5% steam quality is required.Get Price
the heat to generate steam in a waste heat boiler, which then drives a steam turbine. Steam turbines are one of the oldest and most versatile prime mover technologies. Heat recovery boiler/steam turbine systems operate thermodynamically as a Rankine Cycle, as shown in Figure 2. In the steam Rankine cycle, the working fluid—Get Price
a boiler or heat recovery steam generator (HRSG). Unlike gas turbines or microturbines, steam turbines do not directly consume fuel. Rather, the fuel driving the process is the fired boiler or plant equipment that produces heat for the HRSG (e.g., a gas turbine). Table 1. Summary of Steam Turbine Attributes for CHPGet Price
Steam from the gasification area SGC is further superheated in the HRSG for the ST generator. Heating of a boiler feedwater prior to the introduction to SGC is also conducted. Part of the GT exhaust gas is extracted and supplied to coal pulverizing and drying process as a coal drying gas with enough sensible heat and volume flow.Get Price
Inevitably the steam begins to do this as soon as it leaves the boiler. The water which forms is known as condensate, which tends to run to the bottom of the pipe and is carried along with the steam flow. This must be removed from the lowest points in the distribution pipework for several reasons.. Condensate does not transmit heat effectively.Get Price
These deposits can slow the passage of steam through the system or block it entirely. In fact, scale is the most significant contributor to efficiency loss in your steam boiler system. Scale buildup can reduce the effectiveness of heat exchangers and prevent hot water in the boiler from reaching the needed temperature.Get Price
Feb 02, 2010 · A steam generator is a wonderful addition to any central heating system. Steam generators are an alternative to conventional boilers. There are many problems that can arise when installing a steam generator. Steam generators require both fuel and water to work properly. Without both, the steam generator won't work.Get Price
In athermal electric power plantthe steam generators (often referred toas "boilers") are a critical energy link between the primary heat source (fossil ornuclear) and the turbine. In nucleargenerating stations the boiler level control system mustfunction properly in orderto provide a continuous heat sinktothe reactor.Get Price